• A wide range of power and frequency sizes to meet any heating need
• "Bullet-Proof" circuitry eliminates nuisance shutdowns and restarts
• Voltage fed for 0.95 input power factor over full operating range
• Output regulation by voltage, power or current. Jumper selected
• Single control board. Field replaceable for easy maintenance and trouble shooting
• Control board interchangeable for any frequency
• Factory calibrated to eliminate field adjustment and calibration
• Modular, single-layer design for easy access and maintenance
• Pressure switches on all capacitors to shut down system if excessive pressure is detected
• Built-in annunciator panel for simplified status/fault diagnostics
• 85 dB operating sound level for quiet operation on shop floor
• Backed by the world's leading builder of induction heating equipment

Job-Matched Induction Heating Power Supplies:

STATIPOWER® SP6 water-cooled, solid state power supplies are designed for forging, mass heating, annealing, extruding and many other induction heating applications. Power and frequency combinations from 150 to 2200 kW/200 to 6000 Hz are available.

"Bullet-Proof" Circuitry For Increased Up-Time:

These STATIPOWER® units incorporate "Bullet-Proof" circuitry to eliminate fuse blowing and to protect inverter components in the event of load faults.

Rugged, High-Power SCRs And Diodes:

The STATIPOWER® units use heavy-duty SCRs and diodes which are selected to run below manufacturer's ratings. This large safety margin adds strongly to system reliability.

Reliable Design For Safety And Long-Life Performance:

These units have a DC diode bridge, line choke and capacitor bank to minimize the effects of line noise and harmonic feedback. Other system features include an input line disconnect with UVR, differential pressure switch and temperature switches on water supply and return manifolds. Options include a remote meter panel and a 4 to 20 ma interface board for external control.

Click For Induction Power Supply Equipment...