• 50-200 kHz with a wide range of power outputs for application flexibility
• Continuous or intermittent duty
• 100% solid state design. Ideal replacement for less efficient oscillator tube power supplies
• High, 0.95 input power factor under all operating conditions
• ±1% output regulation accuracy with ±10% line variance under all operating conditions
• Single control board for reliable operation and simplified maintenance
• Analog display of voltage, frequency, current and output power. Built-in digital heat timer
• Optional RS-232/485 interface for automatic operation under computer control
• Built-in load matching capacitors and variable ratio isolation transformer
• Built by the world's largest designer and manufacturer of induction heating equipment

RF Power Supply For General Purpose Induction Heating

The STATIPOWER® SP11 is a self-contained, stand-alone solid state transistorized power supply for heating a wide variety of parts. Application capabilities include hardening, tempering, brazing, soldering, melting, bonding and shrink fitting. A broad range of single-turn and other low impedance heating coils can be properly matched with built-in load tuning capacitors and multi-tap output isolation transformer.

Compact Design For Stand Alone Operation

STATIPOWER® SP11 power supplies are up to 80% smaller and up to 2,000 lbs. lighter than conventional RF power supplies. This efficient use of space is achieved without sacrificing performance. Output power regulation is ±1% with up to ±10% line variance; the input power factor is 0.95, regardless of loading; and energy conversion efficiency exceeds 85% (a tube style RF oscillator is typically 50% efficient to the load).

Manual Or Computer Controlled Operation

All controls necessary for stand-alone operation are built into STATIPOWER® SP11 power supplies. This includes a digital heat cycle timer, analog meters for voltage, frequency, current and power, and LED operating and diagnostic indicators. For automatic control and/or record keeping, an optional RS-232/485 interface is available. The only installation requirements are power and water.

Click For Induction Power Supply Equipment...